2600-00FK1RGA4
Ver.
3.5.1.2 ACL Rule Configuration
Configuration using CLI
1) Go to interface configuration mode where you will apply the configure ACL rule of
CLI.
APC# configure terminal
APC/configure# interface [name]
APC/configure/interface [name]#
2) Configure ACL to an interface.
ip access-group [MODE] [DIRECTION] [ACL_NAME]
Parameter
MODE
DIRECTION
ACL_NAME
An example of entering a command that configures 'acl1' to the 'ge2' interface is
shown below.
APC# configure terminal
APC/configure# interface ge2
APC/configure/interface ge2#ip access-group fqm in acl1
3) To check the configuration information, use the 'show running-config network'
command.
Configuration using Web UI
In the menu bar of <WEC Main window>, select <Configuration> and then select the
<Security> <Access Control Lists> <Access Group(Interface)> menu in the sub-
menus.
The initial window of WLAN ACL configuration is shown below. When you click the
<Add> or <Delete> button, you can add or delete ACL rule.
© SAMSUNG Electronics Co., Ltd.
3.0
Configuration mode (fw/fqm)
Application direction configuration (in/out)
ACL name to configure
Figure 38. ACL Interface Configuration Window (1)
CHAPTER 3. Data Network Function
Description
page 108 of 496