Table of Contents
Advertisement
2.
Align the LMG-44/LMGP-44 module's retainer screws with the screw
holes on the slot bay and carefully seat the module.
3.
Tighten the retaining screws to fully seat the module.
To remove the LMG-44/LMGP-44 module already installed in the
iBG3026:
1.
Locate the slot from which you plan to remove an installed module.
2.
Loosen the two retainer screws.
3.
Pull the module straight out of the module bay.
4.
To install the mid-span support for installing half-width cards, snap the
support into position.
© SAMSUNG Electronics Co., Ltd.
Figure 4.57 Aligning the new Network Module
Ubigate iBG3026 Installation Manual/Ed.01
75
Advertisement
Table of Contents
