I/O Board 4 - Tektronix Phaser 360 Service Manual

8
Field Replaceable Unit Disassembly/Assembly

I/O board 4

8-52 Phaser 360 Color Printer
5. Remove the three screws securing transfix solenoid/sensor bracket to
the engine frame. Remove the bracket.
Figure 8-32 Removing I/O board right and the transfix solenoid/sensor bracket
Note Refer to Appendix C "Wiring Diagrams" for details on where each
wiring harness connector plugs into the I/O boards. Additionally,
each connector receptacle on the boards is labeled for its wiring
harness.
I/O board 4 is an integral part of the paper preheater. If I/O board 4 fails and
must be replaced, replace the paper preheater. Refer to the earlier topic "Paper
preheater" on page 8-17.
I/O board 2
Transfix solenoid/
sensor bracket
Remove
screws
Remove
screws
9923-62