Connecting The Printer To A Pc; Direct Connection To A Pc; Networked Connection To A Pc Using The Printer's Ethernet Port; Connecting The Printer To A Workstation - Tektronix Phaser 360 Service Manual

Connecting the printer to a PC

Connecting the printer to a workstation

Direct connection to a PC

1.
Turn off the printer. Turn off the host computer.
2. Attach the parallel interface cable to the host computer; attach the
other end to the printer.
3. Turn on the printer first and then the computer.

Networked connection to a PC using the printer's Ethernet port

In the Novell network, the printer is connected to the network in the same
manner as workstations using an Ethernet connection.
Note If the optional 100baseT Ethernet or TokenRing card is installed, the
built-in Ethernet connector is disabled.
1.
Turn off the printer.
2. Connect the interface cable to the printer's Ethernet connector.
3. Turn on the printer.

Direct connection to a workstation

1.
Turn off the printer. Turn off the host computer.
2. Attach the parallel interface cable to the workstation; attach the other
end to the printer.
3. Turn on the printer and the computer.

Networked connection to a workstation

Note If the optional Ethernet or TokenRing card is installed, the built-in
Ethernet connector is disabled.
1. Turn off the printer.
2.
In the case of an Ethernet network, connect the interface cable to the
printer's Ethernet connector.
3. Turn on the printer.
Installing the Printer and Drivers
Service Manual
2
2-11