Pick Roller - Tektronix Phaser 360 Service Manual

Pick roller

Tools required
Magnetic screwdriver
T-15 TORX tip
1. Turn off the printer and remove the power cord. Remove the paper
tray.
2. Remove the right-side and left-side covers as explained in the earlier
topic, "Cabinet panels and covers" on page 8-4. Open the front cover.
3.
Disconnect the wiring harnesses leading to I/O board 1. Remove
I/O board 1; it is held in place with five screws.
Caution To avoid damaging the printhead and drum, rotate the process
motor clockwise to bring the printhead to the print position.
Otherwise, the printhead will be pulled to the print position by the
tilt spring and may damage both the printhead and drum.
4. Remove the feed roller clutch drive gear; it is held in place with an
E-ring.
5. Loosen the paper path drive belt. Remove the belt and the paper path
drive gear; it is held in place with an E-ring.
6. Remove the pick roller clutch.
7. Remove the E-ring securing the pick roller shaft. The E-ring is located
on the inside of the engine side frame.
Caution
Be careful not to scratch the drum when you remove the pick roller.
Field Replaceable Unit Disassembly/Assembly
T-20 TORX tip
Small screwdriver or E-ring puller
Service Manual
8
8-43