8
Field Replaceable Unit Disassembly/Assembly
X-axis drive assembly
Figure 8-20 Removing the X-axis drive assembly
8-32
Phaser 360 Color Printer
Tools required
Magnetic screwdriver
3/32 hex wrench
1.
Turn off the printer and remove the power cord.
2.
Remove the top and right-side covers as explained in the earlier topic,
"Cabinet panels and covers" on page 8-4.
3.
Disconnect the wiring harness leading to the X-axis motor.
4.
Disconnect the X-axis home sensor from I/O board 2.
5.
Remove the three screws securing the assembly in place.
6.
Lift the X-axis motor assembly up and to the rear to clear the
printhead shaft and then remove the assembly.
Reverse this procedure to reinstall the X-axis drive assembly.
T-20 TORX tip
During installation
insert 3/32" hex
wrench in the end
of the screw and
tilt the screw to
slip the assembly
over the end of the
shaft
9923-50