Setting Up The Phaser 360 Printer Driver; Setting Up The Apple Laserwriter 8 Printer Driver - Tektronix Phaser 360 Service Manual

2
Installing the Printer and Drivers

Setting up the Phaser 360 printer driver

Setting up the Apple LaserWriter 8 printer driver

2-24 Phaser 360 Color Printer
Use with System Software 6.0.7, or 7.0 and later.
1. Select Chooser from the Apple menu after installing the printer's
software.
2. Click on the icon of the Phaser 360 printer driver (on the left side of
the Chooser).
3.
Click on the Zone for your printer. See your network administrator if
you have questions.
4. Select your printer from the list of printers on the right side of the
Chooser. If it is not in the list, check your hardware connections and
which zone you have selected in the Chooser.
5.
Close the Chooser.
1. Select Chooser from the Apple menu after installing the printer's
software).
2. Click on the icon of the LaserWriter 8 printer driver (on the left side of
the Chooser).
3. Click on the Zone for your printer. Refer to the configuration page
which lists the name of the zone it is installed into.
4. Select your printer from the list of printers on the right side of the
Chooser. If it is not in the list, check your hardware connections and
which zone you have selected in the Chooser.
5. Click Setup. The printer driver will automatically select the correct
PPD file for the Phaser 360. If it does not, select the PPD file
TKP360P1.PPD.
Check the Configuration Page for your printer's configuration
information
6.
Close the Chooser.