Figure 8-19 Removing The Cap/Wipe/Purge Drive Motor - Tektronix Phaser 360 Service Manual

Reverse these steps to reinstall the motor. Leave the two screws that secure the
motor to the printer's side frame loose until you attach the right-side
cap/wipe/purge belt tension spring, then tighten the screws. Following
reassembly, perform the adjustment procedure "Cap/wipe/purge assembly belt
adjustments" on page 9-11 to assure that the left and right belts are properly
aligned to each other.
Right
cap/wipe/purge belt

Figure 8-19 Removing the cap/wipe/purge drive motor

Field Replaceable Unit Disassembly/Assembly
Right
cap/wipe/purge
belt tension spring
Cap wipe purge
drive gear
Cap wipe purge
motor assembly
Service Manual
8
9923-101
8-31