Figure 8-16 Removing The Drum/Transfix Assembly (Right Side) - Tektronix Phaser 360 Service Manual

11. Right side. Remove the drum fan, shield and drum heater and the
drum gear.
12. Remove the Y-axis belt drive assembly and its belts. If necessary, refer
to the previous procedure, "Y-axis belt drive assembly" on page 8-15.
13. Disconnect the wiring harnesses leading to the transfix
solenoid/sensor bracket. Remove the three screws securing the
bracket in place and remove the bracket.
14. Remove the five screws securing the right side of the drum/transfix
assembly to the print engine. Note that one screw is removed with a
hex key.
15. Remove the exit roller gear train; it is held onto the exit roller shaft by
an E-ring.
16. Remove the E-ring and bushing at the right end of the paper
preheater's feed roller. (It's not necessary to remove the E-ring, gear
and bushing on the left end of the preheater's feed roller.)
Figure 8-16 Removing the drum/transfix assembly (right side)
Field Replaceable Unit Disassembly/Assembly
Transfix solenoid/
sensor bracket
Service Manual
8
Paper exit
gear train
Hex key
screw
9923-48
8-25