Cabinet Panels And Covers - Tektronix Phaser 360 Service Manual

8
Field Replaceable Unit Disassembly/Assembly

Cabinet panels and covers

8-4 Phaser 360 Color Printer
Tools required
Magnetic screwdriver
T-20 TORX tip
Flat-blade screwdriver
1. Unplug the printer.
2. Top cover: Vacuum dust out of the top cover before you remove it
a. Open the ink load door and tilt it back as far as it will travel to
unclip its arms from the top panel.
b. Slide the ink loader's spring crossarm to the rear of the ink loader.
Note how pins on the ends of the ink-loader crossarm align with
notches in the top panel for removal.
c. Remove the four screws securing the top panel in place.
d. Tilt up the rear-end of the top panel and lift and remove the top
cover.
3. Right-side panel:
a. Open the front cover.
b. Remove the two screws securing the right-side cover in place.
c. Remove the right-side cover.
4. Left-side panel: Remove the single screw securing the left-side cover in
place.
5. Rear panel: With the right and left-side panels removed, remove the
single screw securing the rear panel in place.
6. Front panel:
a. Press the front cover release lever to raise its cover retaining
pawls.
b. Slide the front panel forward slightly to clear the pawls.
Disconnect the front panel display wiring harness. Remove the
front panel.
7. Front cover:
a. With a flat blade screwdriver, press the release lever for each of the
two front cover pivots.
b. Remove the front cover.