8
Field Replaceable Unit Disassembly/Assembly
Cap/wipe/purge drive motor
8-30
Phaser 360 Color Printer
Tools required
Magnetic screwdriver
T-15 TORX tip
1.
Turn off the printer and remove the power cord.
2.
Remove the top, front panel, right-side and left-side covers as
explained in the topic, "Cabinet panels and covers" on page 8-4.
3.
Unhook the right-side cap/wipe/purge belt tension spring.
4.
Remove the two screws securing the cap/wipe purge motor assembly
to the printer's side frame.
5.
Remove the plate securing the cap/wipe/purge assembly drive gear.
Remove the gear off of its shaft.
6.
Disconnect the motor's wiring harness and free the motor from the
cap/wipe/purge drive belt.
T-20 TORX tip