Installing A Scsi Hard Disk Drive On A Phaser 360; Figure 2-3 Connecting A Scsi Hard Disk Drive To A Phaser 360 - Tektronix Phaser 360 Service Manual

2
Installing the Printer and Drivers

Installing a SCSI hard disk drive on a Phaser 360

2-12 Phaser 360 Color Printer
Perform this procedure if the customer has a hard disk drive available for font
storage.
1. Make sure that the printer and the SCSI disk drive are turned off.
2. Set the SCSI drive address to a value between 1 and 6.
3.
Attach the SCSI cable to the printer's SCSI port. The printer may
require the SCSI cable (part numbered 013-1465-00) to connect the
drive's standard 50-pin SCSI connector to the smaller, high-density
SCSI connector on the printer's rear panel.
4. Attach the other end of the SCSI cable to the SCSI drive.
5.
Attach a terminator to the SCSI drive's second connector. (This is not
required if the disk drive is internally terminated.)
Disk
drive

Figure 2-3 Connecting a SCSI hard disk drive to a Phaser 360

6. Turn on the disk drive first, wait a few seconds, and then turn on the
printer.
7. Refer to the Phaser 360 Driver and Utilities Printing Reference for details
on formatting a SCSI disk, controlling Sys/Start job files, and using the
LaserWriter Utility to load fonts onto the disk drive.
Disk drive
SCSI
Terminator
PHASER 360 SCSI Disk
Ethernet®
RESET
RCV XMT
1 2 3 4
Service
PS PE
Only
Parallel Second
Network Adapter LNK Ethernet
Feeder
Phaser 360 SCSI
9923-10