Power Control Board - Tektronix Phaser 360 Service Manual

Power control board

Tools required
Magnetic screwdriver
T-15 TORX tip
1. Turn off the printer and remove the power cord.
2. Remove the top, rear, left-side and right-side covers as explained in
the earlier topic, "Cabinet panels and covers" on page 8-4.
3.
Remove the ink loader as detailed earlier in the topic, "Ink loader" on
page 8-6.
4. Remove the 12 screws securing the rear plate to the engine frame. Lift
the plate and attached fan out of the way.
5.
Disconnect the wiring harnesses leading to the power control board.
6. Remove the two vacuum accumulator securing screws. Remove the
vacuum accumulator.
Field Replaceable Unit Disassembly/Assembly
T-20 TORX tip
Service Manual
8
8-53