8
Field Replaceable Unit Disassembly/Assembly
8-38
Phaser 360 Color Printer
Reverse these steps to reinstall the cap/wipe/purge assembly. Upon
reassembly, be sure to install the large double-insulated wire into the
cap/wipe/purge assembly bracket last; it is used to hold the two smaller wires
in place. Secure the wiring to the metal vacuum tube with a twist-tie or
tie-wrap. Refer to "Wiring Diagrams" for details on dressing the
cap/wipe/purge wiring.
Pin screw
Figure 8-23 Removing the cap/wipe/purge assembly
Vacuum
inlet
Cap wipe/purge
assembly
Pin screws
9923-53