Figure 5-11 The Cap/Wipe/Purge Assembly And Vacuum System - Tektronix Phaser 360 Service Manual

Vacuum for the purge cycle is obtained from a vacuum pump and a vacuum
accumulator. A small vacuum pump, running for 75 to 90 seconds, creates a
strong vacuum in the vacuum accumulator. Then an air valve is energized for a
fraction of a second, exposing the printhead faceplate to the strong, accumulated
vacuum to suck debris and bubbles out of the printhead nozzles. With the air
valve once again de-energized, air is metered through the 7-mil orifice to
gradually release the vacuum at the faceplate.
Cap/wipe/purge assembly transport
Drum
Cap/wipe/purge assembly
home sensor (on I/O board right)
Vacuum system
Pump
Vacuum
accumulator

Figure 5-11 The cap/wipe/purge assembly and vacuum system

Printhead
Cap/wipe/purge
assembly belt
Solenoid valve "unenergized"
Air
Solenoid valve "energized"
Theory of Operation
Cap/wipe/purge
assembly motor
Cap/wipe/purge
assembly
Wiper blade
Cap/wipe/purge assembly
Filter Air
7 mil
orifice
9923-21
Service Manual
5
5-13