I/O Board Right And Transfix Solenoid/Sensor Bracket - Tektronix Phaser 360 Service Manual

I/O board right and transfix solenoid/sensor bracket
Tools required
Magnetic screwdriver
T-15 TORX tip
1. Turn off the printer and remove the power cord.
2. Remove the right-side cover as explained in the earlier topic, "Cabinet
panels and covers" on page 8-4.
3. I/O board right:
a. Disconnect the wiring harnesses leading to I/O board right.
b. Remove the five screws securing I/O board right to the engine
frame.
c. Remove the board.
4. I/O board 3:
a. Disconnect the wiring harness from transfix solenoid/sensor
bracket.
b. Disconnect the remaining wiring harnesses.
Field Replaceable Unit Disassembly/Assembly
T-20 TORX tip
Service Manual
8
8-51