Table 1-6 Electrical Specifications(Tbd) - Tektronix Phaser 360 Service Manual

Table 1-6 Electrical specifications(tbd)

Characteristic
Primary line voltages
Primary voltage
frequency range
Power consumption
Current rating
Fusing
Secondary voltages
RF emissions
Specification
87 to 132 VAC (115 VAC nominal)
174 to 264 VAC (220 VAC nominal)
Input voltage range is auto-sensed.
47 to 63 Hz
200 watts standby; 300 watts at idle; 600 during printing.
Maximum power consumption 1000 watts during warm-up.
115 VAC configuration – 8 amp max./1 amp min.
220 VAC configuration – 4 amp max./1 amp min.
F1: DC switcher - 6.3 amp slo-blo
F2: Drum heater 1, reservoir heater 1, ink melt chambers,
cap/wipe/purge unit - 10 amp slo-blo
F3: Jet stack left and right, paper pre-heaters, reservoir
heaters 2,3,and 4 10 amp slo blo
Fuses are not user-accessible.
+5
V ± 2%
+12 V ± 5%
-12 V ± 5%
+40 V -5%, +12%
-40 V ± 10%
+54 V ± 10%
Both 115 and 220 VAC-configured instruments pass these
standards: EN55022 (CISPR 22) class B
EN61000-3-2 AC mains Harmonic Distortion
EN61000-3-3 Flicker on AC Mains Susceptibility
(EN50082-1:1994)
IEC 1000-4-2:1993 Electro-Static Discharge
ENV50140:1993 Radiated RF Immunity
IEC1000-4-4:1993 Fast Burst Transients EN61000-4-11:1993
Voltage Dips and Interruptions
IEC 1000-4-5:1993 Line Surge
General Information
Service Manual 1-19
1