Drum Fan; Figure 8-5 Removing The Drum Fan - Tektronix Phaser 360 Service Manual

Drum fan

Tools required
Magnetic screwdriver
T-20 TORX tip
1. Turn off the printer and remove the power cord.
2. Remove the top and right-side covers as explained in the earlier topic,
"Cabinet panels and covers" on page 8-4.
3.
Remove the ink loader as detailed in the topic, "Ink loader" on
page 8-6.
4. Disconnect the wiring harnesses leading to the drum fan from the
power control board's connector J5. Also disconnect the fan sense
wiring harness from I/O board Right.
5.
Remove the three screws securing the drum fan in place. Remove the
fan. The drum fan, shield and heater should always be replaced as a unit .
J 5
Drum heater
wiring harness
Fan sense
wiring harness

Figure 8-5 Removing the drum fan

Reverse these steps to install the fan. Note the orientation notch in the
lower right corner of the shield . Ensure the spring clip is installed on the
side of the fan. Refer to Appendix C "Wiring Diagrams" for an
illustration showing how to dress the drum fan wiring.
Field Replaceable Unit Disassembly/Assembly
T-15 TORX tip
Drum fan
wiring harness
Drum
heater
Shield
Drum
fan
Spring
clip
9923-39
Service Manual 8-9
8