Head Tilt Cam Gear - Tektronix Phaser 360 Service Manual

Head tilt cam gear

Tools required
Magnetic screwdriver
T-15 TORX tip
1.
Turn off the printer and remove the power cord.
2. Open the top cover.
3. Remove the top cover and left-side covers.
4.
Disconnect the wiring harnesses leading to I/O board 1.
5. Remove I/O board 1 as detailed in the procedure "I/O board 1" on
page 8-50.
6. Remove the E-ring securing the head tilt cam gear to the its printer
frame shaft.
7. Rotate the process motor gear clockwise to place the printhead in its
print position (tilt forward position).
8. Move the printhead's x-axis to the home position. The head tilt arm
should be away from the cam.
9.
Remove the cam follower pin's securing screw and adjuster from the
lower end of the tilt arm.
Field Replaceable Unit Disassembly/Assembly
T-20 TORX tip
Small screwdriver or E-ring puller
Service Manual
8
8-45