Drum/transfix assembly
Tools required
Magnetic screwdriver
3/32-inch hex key
1.
Turn off the printer and remove the power cord.
2.
Remove the top, front panel, right-side and left-side covers as
explained in the earlier topic, "Cabinet panels and covers" on
page 8-4.
3.
Remove the ink loader as explained in the previous procedure, "Ink
loader" on page 8-6.
4.
Left side. Free the wiring harness leading from the drum/transfix
assembly along the left side of the print engine to the power control
board.
5.
Remove the drum position sensor assembly. If necessary, refer to the
previous procedure, "Drum position sensor assembly" on page 8-20.
Field Replaceable Unit Disassembly/Assembly
T-20 TORX tip
T-15 TORX tip
Service Manual
8
8-23