Adjustments; Paper-Feed Belt Tension Adjustment; Figure 9-3 Setting Paper-Feed Belt Tension - Tektronix Phaser 360 Service Manual

9
Checks and Adjustments

Adjustments

Paper-feed belt tension adjustment

9-6 Phaser 360 Color Printer
1. Turn off the printer and remove the left-side cabinet panel.
2.
With a spring scale, press inward on the right side of the paper-feed
belt. When properly set you should measure about 1 to 7 ft./lbs.
(1/4 to 1/2 inches of deflection, 6 to 12 mm).
To adjust the belt tension, loosen the paper-feed belt tensioner, adjust
its position for proper belt tension and then tighten the tensioner in
place. Do not over-tension the belt.

Figure 9-3 Setting paper-feed belt tension

3.
Reinstall the left side panel.
Paper feed
belt tensioner
Press here to
check belt deflection
9923-71