Subaru 2002 IMPREZA Service Manual page 476

ENGINE (DIAGNOSTICS)
1. PREPARATION FOR THE INSPECTION
MODE
1) Make sure that the fuel remains approx. half
amount [20 — 40 2 (5.3 — 10.6 US gal, 4.4 — 8.8
Imp gal)] and the battery voltage is 12 V or more.
2) Raise the vehicle using a garage jack and place
on safety stands or drive the vehicle onto free roll-
ers.
WARNING:
• Before raising the vehicle, ensure the parking
brake is applied.
• Do not use a pantograph jack in place of a
safety stand.
• Secure a rope or wire to the front and rear
towing or tie-down hooks to prevent the lateral
runout of front wheels.
• Do not abruptly depress/release the clutch
pedal or accelerator pedal during works even
when engine is operating at low speeds since
this may cause vehicle to jump off free rollers.
• In order to prevent the vehicle from slipping
due to vibration, do not place any wooden
blocks or similar items between the safety
stands and the vehicle.
• Since the rear wheels will also rotate, do not
place anything near them. Also, make sure that
nobody goes in front of the vehicle.
(A) Safety stand
(B) Free rollers
INSPECTION MODE
2. SUBARU SELECT MONITOR
1) After performing the diagnostics and clearing the
memory, check for any remaining unresolved trou-
ble data. <Ref. to EN-49, Clear Memory Mode.>
2) Warm up the engine.
3) Prepare the Subaru Select Monitor kit. <Ref. to
EN-9, PREPARATION TOOL, General Descrip-
tion.>
4) Connect the diagnosis cable to Subaru Select
Monitor.
5) Insert the cartridge into Subaru Select Monitor.
<Ref. to EN-9, PREPARATION TOOL, General
Description.>
6) Connect the test mode connector (A) at the low-
er portion of instrument panel (on the driver's side).
B2M2969C
EN-44
S2M0285
S2M0286A
(A)
EN0773