DIAGNOSTICS FOR ENGINE STARTING FAILURE
ENGINE (DIAGNOSTICS)
Step
10
CHECK INHIBITOR SWITCH CIRCUIT.
1)Turn the ignition switch to OFF.
2)Place the selector lever in the "P" or "N" posi-
tion.
3)Separate the transmission harness connec-
tor.
4)Measure the resistance between transmis-
sion harness connector receptacle's terminals.
Connector & terminal
(T3) No. 11 — No. 12:
11
CHECK TRANSMISSION HARNESS.
1)Disconnect the connector from inhibitor
switch.
2)Measure the resistance of harness between
transmission harness and inhibitor switch con-
nector.
Connector & terminal
(T3) No. 11 — (T7) No. 7:
12
CHECK POOR CONTACT.
Check poor contact in inhibitor switch connec-
tor.
Check
Is the resistance less than 1
Ω?
Is the resistance less than 1
Ω?
Is there poor contact in inhibi-
tor switch connector?
EN-66
Yes
Repair the open
Go to step 11.
circuit in harness
between starter
motor and ignition
switch connector.
Go to step 12.
Repair the open
circuit in harness
between transmis-
sion harness and
inhibitor switch
connector.
Repair the poor
Replace the inhibi-
contact in inhibitor
tor switch.
switch connector.
No