Subaru 2002 IMPREZA Service Manual page 416

STARTING/CHARGING SYSTEMS
B: INSTALLATION
Install in the reverse order of removal.
Tightening torque:
50 N·m (5.1 kgf-m, 37 ft-lb)
C: DISASSEMBLY
1. STARTER ASSEMBLY
1) Loosen the nut which holds terminal M of switch
assembly, and then disconnect the connector.
(A) Terminal M
(B) Terminal B
(C) Terminal S
STARTER
2) Remove the bolts which hold switch assembly,
and then remove the switch assembly, plunger and
plunger spring from starter as a unit.
CAUTION:
Be careful because the pinion gap adjustment
washer may sometimes be used on the mount-
ing surface of switch assembly.
EN1007
3) Remove both through-bolts and brush holder
screws, and then detach the rear bracket and brush
holder.
CAUTION:
Before removal, confirm the attachment loca-
tions of brush holder and rear bracket.
B2M4454A
SC-6
(A) Switch ASSY
(B) Plunger
(A) Brush holder
(B) Rear bracket
B2M4455A
H6M0494B