10) Remove the accelerator pedal connecting bolt
from accelerator pedal bracket.
• LHD MODEL
• RHD MODEL
11) Disconnect the grommet from toe board.
NOTE:
From the inside compartment, push the grommet
(A) into hole.
12) Pull out the cable from toe board hole.
ACCELERATOR PEDAL
13) Disconnect the accelerator cable bushing from
accelerator pedal lever.
EN0924
14) Disconnect the accelerator cable stopper (A)
from bracket.
EN0925
15) Separate the accelerator cable and bracket.
B: INSTALLATION
1) Install in the reverse order of removal.
CAUTION:
• If the cable clamp is damaged, replace it with
a new one.
• Never fail to cover the outer cable end with
boot.
• Be careful not to kink the accelerator cable.
• Always use new clevis pins.
B4M1740C
SP-5
SPEED CONTROL SYSTEMS
(A) Slot type screwdriver
B4M1741B
B4M1742B