Subaru 2002 IMPREZA Service Manual page 233

17) Separate the torque converter clutch from drive
plate. (AT model)
(1) Lower the vehicle.
(2) Remove the service hole plug.
(3) Remove the bolts which hold torque con-
verter clutch to drive plate.
(4) Remove other bolts while rotating the en-
gine using ST.
ST 499977300 CRANK PULLEY WRENCH
(1600 cc and 2000 cc model)
ST 499977100 CRANK PULLEY WRENCH
(2500 cc model)
18) Remove the pitching stopper.
19) Disconnect the fuel delivery hose, return hose
and evaporation hose.
CAUTION:
• Disconnect the hose with its end wrapped
with cloth to prevent fuel from splashing.
• Catch fuel from the hose into container.
ENGINE ASSEMBLY
20) Support the engine with a lifting device and
wire ropes.
21) Support the transmission with a garage jack.
CAUTION:
Before moving the engine away from transmis-
sion, check to be sure no work has been over-
looked. Doing this is very important in order to
facilitate re-installation and because the trans-
mission lowers under its own weight.
S2M0207
H3M1839 BO0002
22) Separation of the engine and transmission.
(1) Remove the starter. <Ref. to SC-5, RE-
MOVAL, Starter.>
(2) Remove the bolts which hold upper side of
transmission to engine.
S2M0500
ME-37
(A) Transmission
(B) Garage jack
MECHANICAL
B2M3391
G2M0298A
B3M2044