Subaru 2002 IMPREZA Service Manual page 414

STARTING/CHARGING SYSTEMS
2. GENERATOR
(1) Pulley
(2) Front cover
(3) Ball bearing
(4) Bearing retainer
C: CAUTION
• Wear working clothing, including a cap, protec-
tive goggles, and protective shoes during opera-
tion.
• Remove contamination including dirt and corro-
sion before removal, installation or disassembly.
• Keep the disassembled parts in order and pro-
tect them from dust or dirt.
• Before removal, installation or disassembly, be
sure to clarify the failure. Avoid unnecessary re-
moval, installation, disassembly, and replacement.
GENERAL DESCRIPTION
(5) Rotor
(6) Bearing
(7) Stator coil
(8) IC regulator with brush
• Be careful not to burn your hands, because each
part in the vehicle is hot after running.
• Be sure to tighten fasteners including bolts and
nuts to the specified torque.
• Place shop jacks or safety stands at the specified
points.
• Before disconnecting electrical connectors of
sensors or units, be sure to disconnect the ground
cable from battery.
SC-4
(9) Brush
(10) Rectifier
(11) Rear cover
(12) Terminal
H6M0493C