STARTING/CHARGING SYSTEMS
7) Remove the overrunning clutch from shaft as-
sembly as follows:
(1) Remove the stopper from ring by lightly tap-
ping the stopper with an appropriate tool (such
as a 14 mm (0.55 in) socket wrench).
(2) Remove the ring, stopper and clutch from
shaft.
(A) Socket wrench
(B) Ring
(C) Shaft
(D) Stopper
STARTER
2. BRUSH HOLDER
Slightly open the metal fitting holding the insulating
plate to brush holder. Remove the insulating plate.
NOTE:
The brush and spring can be easily removed from
the brush holder at this time.
B2M4769A
SC-8
(A) Brush holder
(B) Insulating plate
(C) Metal fitting
H6M0497B