4) Remove the armature and yoke. The ball used
as a bearing will then be removed from the end of
armature.
CAUTION:
Be sure to mark an alignment mark on the yoke
and front bracket before removing yoke.
(A) Armature
(B) Ball
(C) Yoke
(D) Front bracket
5) Remove the packing A, three planetary gears,
packing B and plate.
CAUTION:
Before removal, confirm the inserting location
of packing A.
(A) Packing A
(B) Planetary gear
(C) Plate
(D) Packing B
STARTER
6) Remove the shaft assembly and overrunning
clutch as a unit.
CAUTION:
Before removal, confirm the following:
• Lever direction
• Internal gear assembly position
H6M0495D
B2M4793A
SC-7
STARTING/CHARGING SYSTEMS
(A) Lever
(B) Shaft ASSY
(C) Overrunning clutch
(D) Internal gear ASSY
B2M4458B