2. RHD MODEL
(1)
Accelerator bracket
(2)
Stopper
(3)
Accelerator pedal lever
(4)
Accelerator pedal spring
(5)
Accelerator pedal
C: CAUTION
• Wear work clothing, including a cap, protective
goggles, and protective shoes during operation.
• Remove contamination, including dirt and corro-
sion, before removal, installation or disassembly.
• Keep the disassembled parts in order and pro-
tect them from dust and dirt.
• Before removal, installation or disassembly, be
sure to clarify the failure. Avoid unnecessary re-
moval, installation, disassembly, and replacement.
• Be careful not to burn your hands, because each
part in the vehicle is hot after running.
• Be sure to tighten fasteners including bolts and
nuts to the specified torque.
• Place shop jacks or safety stands at the specified
points.
• Before disconnecting electrical connectors of
sensors or units, be sure to disconnect the ground
cable from battery.
GENERAL DESCRIPTION
(6)
Spring pin
(7)
Accelerator spring
(8)
Bushing
(9)
Clip
(10)
Accelerator stopper
SP-3
SPEED CONTROL SYSTEMS
(11)
Kick-down switch (AT model).
Tightening torque: N·m (kgf-m, ft-lb)
T: 18 (1.8, 13.0)
EN1493