Multi-Function Input Settings; Multi-Function Input Selection - Omron RX Series User Manual

5-9

Multi-function Input Settings

5-9-1

Multi-function Input Selection

• You can allocate any of the following functions to the multi-function input terminals S1 to S8 to use
them.
To do so, set the Multi-function Input S1 to S8 Selection (C001 to C008) according to the table below.
• Do not allocate the same function to more than one multi-function input terminal. If you allocate the
same function to two or more multi-function input terminals by mistake, the function will be set only for
the terminal to which you allocated the function last and the terminal to which the function is allocated
previously will be reset to 255 (no: No allocation).
• This section describes seven types of primary functions. For other functions, refer to 7-5
Multi-function Terminal Functions (Group C) on page 7-108.
Parameter
Data
No.
01
02
03
04
05
06
09
Multi-function
18
Input S1 to
20
S8 Selection
(C001 to
21
C008)
22
32
33
34
35
36
37
38
High-function General-purpose Inverter 3G3RX-V1 User's Manual (I578-E1)
Function name
RV: Reverse
CF1: Multi-step speed setting binary 1
CF2: Multi-step speed setting binary 2
CF3: Multi-step speed setting binary 3
CF4: Multi-step speed setting binary 4
JG: Jogging
2CH: 2-step
acceleration/deceleration
RS: Reset
STA: 3-wire start
STP: 3-wire stop
F/R: 3-wire forward/reverse
SF1: Multi-step speed setting bit 1
SF2: Multi-step speed setting bit 2
SF3: Multi-step speed setting bit 3
SF4: Multi-step speed setting bit 4
SF5: Multi-step speed setting bit 5
SF6: Multi-step speed setting bit 6
SF7: Multi-step speed setting bit 7
5 Basic Settings
Reference item
Reverse run command
Multi-step speed operation function
Jogging operation function
2-step acceleration/deceleration
function
Reset
3-wire input function
Multi-step speed operation function
Page
5-52
5-53
5
5-56
5-57
5-57
5-58
5-53
5 - 51