Multi-Function Input Settings; Multi-Function Input Selection - Omron MX2 Series User Manual

5-9

Multi-function Input Settings

5-9-1

Multi-function Input Selection

• You can allocate the functions shown in the following table to the multi-function input terminals S1 to
S7 to use them.
• This section describes seven types of primary functions. For other functions, refer to 7-2
Multi-function Input/Output Functions on page 7-18.
To allocate the functions, set the values shown in the Data column of the following table in the
Multi-function Input S1 to S7 Selection (C001 to C007).
• Do not allocate the same function to more than one multi-function input terminal. If you allocate the
same function to more than one multi-function input terminal by mistake, the function will be set only
for the terminal to which you allocated last and the previously allocated terminal will be reset to 255
(no: No allocation).
Parameter
No.
Multi-function
Input S1 to S7
Selection
(C001 toC007)
Multi-function Compact Inverter 3G3MX2-V1 User's Manual (I585-E1)
Data Function name
00 FW: Forward
01 RV: Reverse
02 CF1: Multi-step speed setting binary 1
03 CF2: Multi-step speed setting binary 2
04 CF3: Multi-step speed setting binary 3
05 CF4: Multi-step speed setting binary 4
06 JG: Jogging
09 2CH: 2-step acceleration/deceleration
18 RS: Reset
20 STA: 3-wire start
21 STP: 3-wire stop
22 F/R: 3-wire forward/reverse
32 SF1: Multi-step speed setting bit 1
33 SF2: Multi-step speed setting bit 2
34 SF3: Multi-step speed setting bit 3
35 SF4: Multi-step speed setting bit 4
36 SF5: Multi-step speed setting bit 5
37 SF6: Multi-step speed setting bit 6
38 SF7: Multi-step speed setting bit 7
5 Basic Settings
Reference item
Forward run command
Reverse run command
Multi-step speed operation
function
Jogging
2-step acceleration/deceleration
Reset
3-wire input function
Multi-step speed operation
function
Page
P. 5-48
P. 5-48
5
P. 5-49
P. 5-52
P. 5-53
P. 5-53
P. 5-54
P. 5-49
5 - 47