Chapter 2
Avaya P460 CLI Commands
The syntax for this command is:
set outband negotiation {enable | disable}
enable
disable
Example:
P460-1# set outband negotiation enable
Auto-negotiation for outband port set successfully
set outband speed
User level: read-write, admin.
Use the set outband speed command to configure the speed of Ethernet
Console port.
In auto negotiation mode, the port's speed is determined by auto negotiation. If you
attempt to set the speed when auto negotiation is enabled, the following message is
displayed "Auto negotiation is Enable, can not set the speed
mode."
The syntax for this command is:
set outband speed <speed>
speed
Example:
P460-1# set outband speed 100MB
Speed for outband port set successfully
84
Enable link negotiation protocol.
Disable link negotiation protocol.
• 10MB
• 100MB
Avaya P460 Reference Guide