Set Port Trap; Set Port Vlan - Avaya P460 Reference Manual

Example:
P460-1# set port static-vlan 3/4-6 2
VLAN 2 is bound to port 3/4
VLAN 2 is bound to port 3/5
VLAN 2 is bound to port 3/6

set port trap

User level: read-write, admin.
Use the set port trap command to enable or disable generic SNMP uplink or
downlink traps from a port.
The syntax for this command is:
set port trap <module>/<port> {enable|disable}
module
port
enable
disable
Example:
P460-1# set port trap 3/2 enable
Port 3/2 up/down trap enabled.

set port vlan

User level: read-write, admin.
Use the set port vlan command to set the port VLAN ID (PVID). If adding a
new VLAN, the VLAN number must be within the range.
You need to define a vlan before setting a port VLAN ID.
Avaya P460 Reference Guide
Number of the module (3-6). If you do not specify a number,
the ports on all the modules are shown.
Number of the port on the module. If you do not specify a
number, all the ports on the module are shown.
You can also specify a range of ports separated by a dash, for
example, 4/5-13 for ports 5 to 13 on module 4.
Enable uplink/downlink traps
Disable uplink/downlink traps
Chapter 2 Avaya P460 CLI Commands
99