Network; Network (Layer 3) - Avaya P460 Reference Manual

The syntax for this command is:
line <number> [string]
number
string
Example:
P460-1(super)# line 5 "P460 CLI"
Done!

network

User level: read-write, admin.
You can only access this command in router-RIP mode.
Type router rip at the command prompt to enter router-RIP mode if
necessary.
Use the network command to specify a list of networks on which the RIP is
running.
Use the no network command to remove an entry.
The syntax for this command is:
[no] network <ip-address> [<wildcard-mask>]
ip addr
wildcard-mask
Example:
To specify that RIP will be used on all interfaces connected to the network
192.168.37.0:
Router-1 (configure router:rip) # network 192.168.37.0
Done!

network (Layer 3)

User level: read-write, admin.
You can only access this command in Router-OSPF mode.
Avaya P460 Reference Guide
Line number in the banner (1...24)
String to be displayed at the given line number (up to 80
characters)
The IP address of the network of directly connected networks
Wildcard mask address. Exists for compatibility with P550.
Chapter 2 Avaya P460 CLI Commands
59