set ppp incoming timeout
User level: read-write, admin.
Use the set ppp incoming timeout command to set the number of minutes
until the system automatically disconnects an idle PPP incoming session.
The syntax for this command is:
set ppp incoming timeout <time>
time
Example:
P460-1# set ppp incoming timeout 15
PPP incoming session will automatically disconnect after 15
minutes of idle time
set qos dscp-agg-index
User level: read-write, admin.
You can only access this command in Configure mode.
Type configure at the command prompt to enter Configure mode if
necessary.
Use the set qos dscp-agg-index command to configure the DSCP aggregate
index.
The syntax for this command is:
set qos dscp-agg-index <dscp> <agg-index>
dscp1
agg-index
Example:
Router-1(configure)#
set qos dscp-cos-map
User level: read-write, admin.
You can only access this command in Configure mode.
Type configure at the command prompt to enter Configure mode if
Avaya P460 Reference Guide
The timeout in minutes
dscp entry (0-63)
aggregate index 0-63
set qos dscp-agg-index 5 3
Chapter 2
Avaya P460 CLI Commands
103