Ip Netmask-Format - Avaya P460 Reference Manual

Chapter 2 Avaya P460 CLI Commands
disable
Example:
To enable rebroadcasting of netbios packets received by and sent from the interface
"marketing":
Router-1(config-if:marketing)# ip netbios-rebroadcast both

ip netmask-format

User level: read-write, admin.
You can only access this command in configure mode.
Type configure at the command prompt to enter configure mode.
Use the ip netmask-format command to specify the format of netmasks in the
show command output.
Use the no ip netmask-format command to restores the default format which is
a dotted decimal.
The syntax for this command is:
[no] ip netmask-format <mask-format>
The possible mask formats are:
bitcount
decimal
hexadecimal
Example:
To display netmasks in decimal format:
Router-1(configure)# ip netmask-format bitcount decimal
Done!
42
Netbios packets are not rebroadcasted into or out of
this interface.
Addresses are followed by a slash and the total number of bits
in the netmask. For example 17
The network masks are in dotted decimal notation. For
example, 255.255.255.0.
The network masks are in hexadecimal format as indicated by
the leading 0X. For example, 0XFFFFFF00.
Avaya P460 Reference Guide