Ip Admin-State; Ip Bootp-Dhcp Network - Avaya P460 Reference Manual

Chapter 2 Avaya P460 CLI Commands

ip admin-state

User level: read-write, admin.
You can only access this command in interface mode.
Type interface [name] at the command prompt to enter interface mode.
Use the admin-state command to set the administrative state of an IP interface.
The default state is up.
The syntax for this command is:
ip admin-state <up/down>
up/down
Example:
Router-1(config-if:marketing)# ip admin-state up

ip bootp-dhcp network

User level: read-write, admin.
You can only access this command in Interface mode.
Type interface [name] at the command prompt to enter Interface mode if
necessary.
Use the ip bootp-dhcp network command to select the network from which
the bootp/dhcp server shall allocate an address. You only need to run this
command is required only when there are multiple interfaces over the VLAN.
Use the no ip bootp-dhcp network command to restore the default value.
The syntax for this command is:
[no] ip bootp-dhcp network <ip-address>
ip-address
Example:
To select the network 192.168.169.0 as the network from which an address shall be
36
Administrative state of the interface. The choices are
up (active) or down (inactive).
The IP address of the network.
Avaya P460 Reference Guide