Chapter 2
Avaya P460 CLI Commands
Normally, the UDP port number should be set to its default value of 1812. Some
early implementations of the RADIUS server used port number 1645.
The syntax for this command is:
set radius authentication udp-port <number>
Example:
P460-1(super)# set radius authentication udp-port number
1645
set slot power
User level: read-write, admin.
Use the set slot power command to power up or power down a slot. If there is
a module in the slot, then the command will reset the device.
The syntax for this command is:
set slot power [Mod {Up|Down}]
Mod
Up
Down
Example 1 – if the slot is empty:
P460-1> set slot power 4 up
slot 4 power is enabled
P460-1> set slot power 4 down
slot 4 power is disabled
108
Module number
Power up the module
Power down the module
Avaya P460 Reference Guide