Show Cam - Avaya P460 Reference Manual

Chapter 2 Avaya P460 CLI Commands
settings.
The syntax for this command is:
show broadcast storm control
Example:
P460-1> show broadcast storm control
Broadcast
Storm Control
----------------
disable

show cam

User level: read-only, read-write, admin.
Use the show cam command to display the CAM table entries for a specific
module and port.
Note: MACs associated with LAGs appear under the LAG ID, not under the LAG
port.
By Module and Port
The syntax for this command is:
show cam [module[/port]]
mac-addr
module
(Optional)
port
(Optional)
122
Threshold
------------
500
MAC address
Number of the module (3-6). If you do not specify a number, all
modules are shown.
Number of the port on the module. If you do not specify a
number, all ports on the specified module are shown.
Avaya P460 Reference Guide