Set Outband Duplex; Set Outband Negotiation - Avaya P460 Reference Manual

Example:
To set the time until the system disconnects an idle session automatically to 20
minutes:
P460-1# set logout 20
Sessions will be automatically logged out after 20 minutes
of idle time.

set outband duplex

User level: read-write, admin.
Use the set outband duplex command to configure the duplex type of the
Ethernet Console port.
You can configure the Ethernet Console interface to either full duplex or half
duplex.
The duplex status of a port in auto-negotiation mode is determined by auto-
negotiation and an error message is generated if you attempt to set the transmission
type of auto-negotiation Fast Ethernet ports to half- or full-duplex mode.
The syntax for this command is:
set outband duplex {full | half}
Full
Half
Example:
P460-1# set outband duplex full
Ethernet Console interface set to full-duplex.

set outband negotiation

User level: read-write, admin.
Use the set outbound negotiation command to enable or disable the link
negotiation protocol on the Ethernet console port.
This command applies to the specific supervisor module where you execute it.
• When negotiation is enabled, the speed and duplex of the outband Ethernet
port is determined by auto-negotiation.
• If negotiation is disabled, you can set the speed and duplex of the outband
Ethernet port.
Avaya P460 Reference Guide
Specifies full-duplex transmission.
Specifies half-duplex transmission
Chapter 2 Avaya P460 CLI Commands
83