traceroute
User level: read-only, read-write, admin.
Provides a trace route utility.
The syntax for this command is:
traceroute <host>
host
Example:
Router-1> traceroute 192.168.50.13
timers spf
User level: read-write, admin.
You can only access this command in Router-OSPF mode.
Type router ospf at the command prompt to enter Router -OSPF mode if
necessary.
Use the timers spf command to set the delay between runs of OSPF SPF
calculation.
Use the no timers spf command to restore the default (3 seconds).
The syntax for this command is:
[no] timers spf <spf-holdtime>
spf-holdtime
Example:
Router-1 (configure router:ospf) # timers spf 5
Done!
validate-group
User level: read-write, admin.
You can only access this command in Configure mode.
Type configure at the command prompt to enter Configure mode if
necessary.
Avaya P460 Reference Guide
Chapter 2
IP address.
The time in seconds of the delay between runs of
OSPF's SPF calculation.
Avaya P460 CLI Commands
183