Redistribute (Rip); Reset - Avaya P460 Reference Manual

Chapter 2 Avaya P460 CLI Commands
Example:
Router-1 (configure router:ospf) # redistribute static

redistribute (RIP)

User level: read-write, admin.
You can only access this command in router-RIP mode.
Type router rip at the command prompt to enter router-RIP mode if
necessary.
Use the redistribute command to redistribute routing information from other
protocols into RIP.
Use the no redistribute command to disable redistribution by RIP.
The default is disabled.
The syntax for this command is:
[no] redistribute <protocol>
protocol
Example:
Router-1 (configure router:rip) # redistribute ospf
Done!

reset

User level: read-only, read-write, admin.
Use the reset command to restart the system or an individual Supervisor module.
The syntax for this command is:
reset [chassis | spvs | 1 | 2]
chassis
spvs
1
64
Either Static or OSPF
• Reset the entire chassis, including the Supervisor and I/O
Modules
• Reset the hardware
• Causes disruption to traffic of 10 to 20 seconds
• Reset both the Supervisor modules
• Minimal disruption to the traffic
Reset Supervisor module in slot 1
Avaya P460 Reference Guide