Set Qos Dscp-Name - Avaya P460 Reference Manual

Chapter 2 Avaya P460 CLI Commands
necessary.
Use the set qos dscp-cos-map command to configure the DSCP table.
The syntax for this command is:
set qos dscp-cos-map <dscp1>[-<dscp2>] <operation>
[<precedence>]
dscp1
dscp
operation
precedence
Example:
Router-1(configure)# set qos dcsp-cos-map 9-16 fwd3

set qos dscp-name

User level: read-write, admin.
You can only access this command in Configure mode.
Type configure at the command prompt to enter Configure mode if
necessary.
Use the set qos dscp-name command to configure the DSCP entry name.
The syntax for this command is:
set qos dscp-name <dscp> <name>
dscp1
name
Example:
Router-1(configure)#
If you wish to define a name which includes spaces, you must enclose the entire
name in quotation marks, for example "new york".
104
dscp range min (0-63)
dscp range max (0-63)
fwd0-7 | no-change
mandatory | optional
dscp entry (0-63)
entry name
set qos dscp-name 10 special
Avaya P460 Reference Guide