No Rmon Alarm - Avaya P460 Reference Manual

Chapter 2 Avaya P460 CLI Commands
Type router ospf at the command prompt to enter Router -OSPF mode if
necessary.
Use the network command to enable OSPF in this network.
Use the no network command to disable OSPF in this network.
The default is disabled.
The syntax for this command is:
network <net addr> [<wildcard-mask> [area <area id>]]
net addr
wildcard-mask
area id
Example:
Router-1 (configure router:ospf) # network 192.168.0.0
Router-1 (configure router:ospf) # area 192.168.0.0
0.0.255.255 area 0.0.0.0

no rmon alarm

User level: read-write, admin.
Use the no rmon history command to delete an existing RMON alarm entry.
The syntax for this command is:
no rmon alarm <Alarm Index>
Alarm Index
P460-1# no rmon alarm 1026
60
IP address
Wildcard mask address
Area ID. This parameter exists for compatibility with
P550.
History index defined using rmon alarm command or P460
Manager.
Avaya P460 Reference Guide