Switching Off Internal Buzzer; Switching External Signaling Devices On And Off; Resetting External Signaling Devices And Transmission Devices - Bosch MPC-xxxx-B Operation Manual

Panel Controller
9.3

Switching off internal buzzer

Press the following key to temporarily switch off the internal buzzer:
The internal signal tone is switched off.
9.4

Switching external signaling devices on and off

Sounders and optical signaling devices which have been activated can be switched off.
1.
NOTICE!
On the next alarm message, all signaling devices that have been switched off are switched
back on automatically.
2.
9.5

Resetting external signaling devices and transmission devices

1.
NOTICE!
The display automatically changes back to alarm indication after 30 seconds.
To return to alarm indication before 30 seconds have elapsed, select Fire.
2.
3.
4.
The control units are reset to the initial state.
In the Control field on the status bar, the number of control elements is reduced by the
number of reset elements.
To reset transmission devices, carry out the same steps, but select Transmission device in
step 1.
Bosch Sicherheitssysteme GmbH
Select Signals off.
The sounder and/or optical signaling device is switched off. The text of the field changes
to Signals on.
To switch the signaling device back on, select Signals on.
The signaling devices are switched on again.
To reset control or transmission devices, select Control in the status bar
Select the signaling device.
Only the activated signaling devices are displayed.
Select one or more list fields.
The list field is marked.
Select Reset.
Operation guide
Fire alarm | en 45
F.01U.076.969 | 6.0 | 2010.04