Ending The Walktest; Ending Walktest For All Elements; Displaying Tested Or Untested Elements - Bosch MPC-xxxx-B Operation Manual

Panel Controller
Example:
1.
2.
3.
4.
15.2.2

Ending the walktest

To end the walktest for this walktest group:
1.
2.
15.3

Ending walktest for all elements

To end the walktest for all walktest groups and elements:
1.
2.
15.4

Displaying tested or untested elements

NOTICE!
You can choose to display either the untested or tested elements in the current walktest.
Select Exit from the status bar.
The following options are offered for the walktest currently being performed:
–
–
Bosch Sicherheitssysteme GmbH
Select Walktest group.
Select Sequential walktest or Simultaneous walktest
A list of walktest groups is displayed. Refer to Section 5.6.1 Scrolling through lists,
page 28 for information on how to navigate through a list.
Select the list field you require.
The field is marked.
Select On.
The selected walktest group is switched to walktest.
Mark the selected walktest group.
Select Off.
Select End from the status bar.
Various possibilities are offered on the display:
Select Yes in order to end the walktest for all walktest groups and elements.
Select No to cancel the operation and return to the previous display.
The walktest is ended for all walktest groups.
Select Not tested to display the elements that showed no reaction during the test or that
have not been tested.
Select Tested to display the elements that were tested and showed a reaction.
Operation guide
Maintenance – walktest | en
F.01U.076.969 | 6.0 | 2010.04
71