Day And Night Mode; Switching Between Day And Night Mode - Bosch MPC-xxxx-B Operation Manual

76 en | Day and night mode
17

Day and night mode

This chapter contains information about the following points:
–
–
The manner in which an incoming alarm is handled depends on whether the system is in day
or night mode; see Section 9 Fire alarm, page 44.
CAUTION!
Night mode is the highest security level as every incoming alarm is forwarded to external
stations.
NOTICE!
Depending on the security level in question, not all detectors can be switched to day mode.
The following symbols on the status bar or standby display show which mode the panel is
switched to. In the case of networked panels, "Day Mode" is displayed until all networked
panels have been switched to night mode. While one panel is still in day mode, the day mode
icon is also displayed on all other panels.
NOTICE!
Please note that following a transmission fault it may be necessary to synchronize the day/
night mode of the other panels manually in order for the current mode to be displayed
correctly.
17.1

Switching between day and night mode

NOTICE!
Depending on the programming, the panel automatically switches from day to night mode at
the preset time.
It is only possible to switch to day mode manually.
There are two ways to switch between day and night mode:
–
–
F.01U.076.969 | 6.0 | 2010.04
Switching between day and night mode
Changing the time for resetting to night mode
Night mode
Day mode
Switching over via the menu
Switching via the status bar
Operation guide
Panel Controller
Bosch Sicherheitssysteme GmbH