62
en | Diagnostics
Display touch test
To test the functionality of the touch-sensitive surface:
1.
2.
3.
4.
5.
Adjust touch screen (calibration)
To adjust the press precision when touching the touch screen:
1.
2.
3.
4.
5.
13.4.3
Serial Interface
Select Serial interface to display the statistical data for the transmission.
13.4.4
CAN-Bus
Select CAN bus to display the status of CAN interfaces.
13.5
Panel Passport
Select Panel passport to display the following diagnostic information:
–
–
–
–
–
–
–
–
–
–
–
F.01U.076.969 | 6.0 | 2010.04
Select Diagnostics in the start menu
Hardware
Display
Select Display touch test.
Touch the touch screen.
A crosshair appears at the touched place.
Press the "back" function key to end the operation.
Select Diagnostics in the start menu
Hardware
Display
Adjust touch screen
Carry out the steps shown on the display.
Module
Address
CAN ID
Production date
BOM revision
PCBA material number
Material number
Software version
Build type
Build number
MAC address
Operation guide
Panel Controller
Bosch Sicherheitssysteme GmbH