Optical And Acoustic Signals; Acknowledging A Message; Silence Internal Buzzer; Activate And Silence Signaling Devices - Bosch FPA‑5000 User Manual

FPA-5000 | FPA-1200 | AVENAR panel 8000 |
AVENAR panel 2000 | AVENAR keypad 8000
–
–
–
9.2

Optical and acoustic signals

–
–
–
If the transmission device to the fire department is activated, the
9.3

Acknowledging a message

There are two ways to acknowledge messages:
–
–
Notice!
If Go to Acknowledge is displayed, select this field in order to display the messages that have
not yet been acknowledged.
9.4

Silence internal buzzer

Press the following key to temporarily silence the internal buzzer:
The internal signal tone is silenced.
9.5

Activate and silence signaling devices

Sounders and optical signaling devices which have been activated can be switched off.
4
Notice!
On the next alarm message, all signaling devices that have been switched off are switched
back on automatically.
4
9.6

Resetting signaling devices and transmission devices

4
Notice!
The display automatically changes back to alarm indication after 30 seconds. To return to the
alarm indication before 30 seconds have elapsed, select Fire.
Bosch Sicherheitssysteme GmbH
Fuchsia: Groups which are actively being controlled without a real alarm, e.g. in case of a
fire drill
Green: Groups which are not active
Yellow: Groups in fault or disabled, no control is possible.
The alarm LED and the evacuation LED
An internal buzzer sounds; see also Silence internal buzzer, page 41 .
Depending on the configuration, sounders and/or visual notification appliances (e.g.
sirens, strobes) are activated.
Select Acknowledge. Only those alarm messages which are visible in the display are
acknowledged.
Select a message and then press Acknowledge. Only the selected message is
acknowledged.
Select Signals off.
The sounder and/or optical signaling device is switched off.
To switch the notification appliance back on, select Signals on.
The signaling devices are switched on again.
To reset control or transmission devices, select Control in the status bar
light up red
User Guide
Fire alarm | en 41
LED icon lights up red:
2020-07 | 3.0 | F.01U.378.877